| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| CC & Talon - ESC telemetry DIY cable https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3813 |
Page 1 of 1 |
| Author: | Bladecrasher [ Sun 15. Mar 2020 20:26:26 ] |
| Post subject: | CC & Talon - ESC telemetry DIY cable |
I followed the directions and made the 10k ohm resistor part and it seems to be working fine. This was on an Oxy3 using a uSpirit. I only had 1/4 watt resistors. It would seem like there isn't going to be much current in this connection but wanted to post this question. Is 1/4 watt sufficient? |
|
| Author: | ZeXx86 [ Tue 17. Mar 2020 22:29:26 ] |
| Post subject: | Re: CC & Talon - ESC telemetry DIY cable |
Hello, yes, it should be enough. It is only for signal path where nearly no current is present. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|