Spirit System • View topic - Geolink Holder 3d print(Oxy 3) (Solved)

It is currently Sun 24. Nov 2024 21:50:09

View unanswered posts | View active topics

Board index » English » HELI » Support

All times are UTC + 1 hour

Geolink Holder 3d print(Oxy 3) (Solved)

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

Pino74

Post subject: Geolink Holder 3d print(Oxy 3) (Solved)

Posted: Mon 03. Feb 2020 21:09:31

Joined: Mon 16. Apr 2018 7:19:02
Posts: 192

Hi can someone put a link of a holder for Geolink for My Oxy 3,to be printed in 3d? I ask why on thingiverse, I found only one, but it does not seem accurate,
attached I inserted the only model that I found on thingiverse, did someone print it? is it accurate?
Thanks

Attachments:

Cattura.JPG [ 46.93 KiB | Viewed 245 times ]

Last edited by Pino74 on Fri 07. Feb 2020 10:32:26, edited 1 time in total.

Top

Pino74

Post subject: Re: Geolink Holder 3d print(Oxy 3)

Posted: Fri 07. Feb 2020 10:32:04

Joined: Mon 16. Apr 2018 7:19:02
Posts: 192

Hi

i have solved

Online on thingiverse I didn't like the one for Oxy 3..one cable tie to fix it, then I printed the one for Oxy2(The best) and I had to slightly modify it,because the diameter of tail boom of the oxy 2 is 2 mm lower than that of the Oxy3, u can see in attachment photo

Thanks

Attachments:

2.JPG [ 83.97 KiB | Viewed 188 times ]

1.JPG [ 76.29 KiB | Viewed 188 times ]

Top

Page 1 of 1

[ 2 posts ]

Board index » English » HELI » Support

All times are UTC + 1 hour

Who is online

Users browsing this forum: No registered users and 44 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: