| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Rudder help https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3751 |
Page 1 of 1 |
| Author: | Badger1666 [ Mon 03. Feb 2020 22:25:54 ] |
| Post subject: | Rudder help |
After setting up spirit2 on a jumper t16 I have a issue, after powering up the rudder slowly goes full travel in one direction and stays there, I can move stick and rudder will move, but will always creep back to full travel on one direction. What can cause this? Thanks |
|
| Author: | Trek nut [ Tue 04. Feb 2020 0:07:16 ] |
| Post subject: | Re: Rudder help |
Hi ! Did you disable your rudder trim ? |
|
| Author: | ZeXx86 [ Tue 04. Feb 2020 13:51:16 ] |
| Post subject: | Re: Rudder help |
Hi, please check Diagnostic tab and verify that Rudder channel is at 0% when sticks are centered. |
|
| Author: | Badger1666 [ Tue 04. Feb 2020 16:59:10 ] |
| Post subject: | Re: Rudder help |
Hi I bind the receiver again and all seems to work on the bench. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|