| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Geolink Holder 3d print(Oxy 3) (Solved) https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3750 |
Page 1 of 1 |
| Author: | Pino74 [ Mon 03. Feb 2020 21:09:31 ] | ||
| Post subject: | Geolink Holder 3d print(Oxy 3) (Solved) | ||
Hi can someone put a link of a holder for Geolink for My Oxy 3,to be printed in 3d? I ask why on thingiverse, I found only one, but it does not seem accurate, attached I inserted the only model that I found on thingiverse, did someone print it? is it accurate? Thanks
|
|||
| Author: | Pino74 [ Fri 07. Feb 2020 10:32:04 ] | |||
| Post subject: | Re: Geolink Holder 3d print(Oxy 3) | |||
Hi i have solved Online on thingiverse I didn't like the one for Oxy 3..one cable tie to fix it, then I printed the one for Oxy2(The best) and I had to slightly modify it,because the diameter of tail boom of the oxy 2 is 2 mm lower than that of the Oxy3, u can see in attachment photo Thanks
|
||||
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|