I'm trying to get Spirit2 set up with FrSKy XSR receiver's SBUS to Spirit2 RUD (along with S. Port from XSR to the FrSky Integration to SYS and daisy chained with Neuron's S. Port out wire)
Taranis shows all the telemetry data—including current and voltage (YES!) but throttle isn't working. In this setup, the Neuron 80a ESC throttle wire goes to Spirit2 AUX1; and the Neuron also has an S. Port output for various telemetry data (RPM, current, voltage, etc.) that I connected with FLVSS and the FrSKy Integration cable.
The SBUS goes from XSR to RUD; (I added extra RED wire from RUD to the S. Port plug from XSR and they plug into FrSky Integration Cable). The FrSky Integration goes to SYS, and has the telemetry devices kind of daisy chained in the middle.
I tested a larger X8R receiver and throttle works only if I put the throttle wire from Neuron into CH3 PWM port on X8R receiver (and SBUS directly to the Spirit2 AUX1, then S. Port on X8R to FrSky Integration and daisy chained telemetry). But that setup won't let me run Spirit2 governor (as far as I can tell).
Does anybody have suggestions? Is it possible to use Spirit2 for throttle governor using XSR SBUS connection?
| Attachments: |
|
File comment: SYS port has Y-Cable for programming and FrSky Integration cable IMG_0112.jpg [ 1.76 MiB | Viewed 482 times ] |
|
File comment: Tried to label what these wires are doing IMG_0105.jpg [ 1.79 MiB | Viewed 483 times ] |
|
File comment: XSR receiver with SBus and S. Port outputs IMG_0101.jpg [ 1.72 MiB | Viewed 513 times ] |