| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Stabi with channel switch https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3711 |
Page 1 of 1 |
| Author: | wcp [ Fri 10. Jan 2020 1:52:03 ] |
| Post subject: | Stabi with channel switch |
I go to "General / Cannels" I assign "F:Stabi Function" to 8" then I go to "Stabi tab" and set Stabalistion (Normal) In my DX9 I assign Aux3 = Channel 8 then I assign channel 8 to switch (G). I can see in the Diagnostic tab "Stabi on and off with my switch. This will give me when the switch is on Stbai in normal mode. I do not use bank switching so this would all be in bank 0. Do I understand this right ? WCP |
|
| Author: | ZeXx86 [ Sat 11. Jan 2020 19:15:35 ] |
| Post subject: | Re: Stabi with channel switch |
Hello, yes, you are right. If you can see it is acting in the Diagnostic tab it will work properly. |
|
| Author: | wcp [ Sat 11. Jan 2020 19:45:23 ] |
| Post subject: | Re: Stabi with channel switch |
Thanks ! Can I tell if Sabi is on by looking at the heli and moving it around ? What might notice different with Stabi on and off ? WCP |
|
| Author: | ZeXx86 [ Sat 11. Jan 2020 19:48:19 ] |
| Post subject: | Re: Stabi with channel switch |
You will see it in the Diagnostic tab as Engaged. It is possible to distinguish behavior of the swashplate, behavior is little bit different. Always return to the center. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|