|
It is currently Sun 24. Nov 2024 23:49:14
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 4 posts ] |
|
| Author |
Message |
|
wcp
|
 Posted: Fri 10. Jan 2020 1:52:03 |
|
Joined: Fri 10. Jan 2020 1:27:07
Posts: 2
|
|
I go to "General / Cannels" I assign "F:Stabi Function" to 8" then I go
to "Stabi tab" and set Stabalistion (Normal)
In my DX9 I assign Aux3 = Channel 8 then I assign channel 8 to switch (G).
I can see in the Diagnostic tab "Stabi on and off with my switch.
This will give me when the switch is on Stbai in normal mode.
I do not use bank switching so this would all be in bank 0.
Do I understand this right ?
WCP
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Sat 11. Jan 2020 19:15:35 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hello,
yes, you are right.
If you can see it is acting in the Diagnostic tab it will work properly.
_________________
Spirit System developer
|
|
| Top |
|
|
|
wcp
|
Posted: Sat 11. Jan 2020 19:45:23 |
|
Joined: Fri 10. Jan 2020 1:27:07
Posts: 2
|
|
Thanks ! Can I tell if Sabi is on by looking at the heli and moving it around ?
What might notice different with Stabi on and off ?
WCP
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Sat 11. Jan 2020 19:48:19 |
|
|
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
You will see it in the Diagnostic tab as Engaged.
It is possible to distinguish behavior of the swashplate, behavior is little bit different. Always return to the center.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: tomsl and 43 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
