| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Spirit Pro/Geolink Setup with DX8 https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3673 |
Page 1 of 1 |
| Author: | DonHoutz [ Mon 09. Dec 2019 15:38:18 ] |
| Post subject: | Spirit Pro/Geolink Setup with DX8 |
I am current setting up a Spirit Pro/Geolink with a DX8 on a TREX600 Nitro. I cannot figure out how to assign all the functions I need with an 8 channel transmitter. Here is my current configuration: - using all 7 transmitter channels for the basic setup with channel 7 assigned to bank switch - using transmitter channel 8 to enable/disable Stabi mode with a 2 position switch - bank 0 setup for Horizon Mode on 3 position switch(position 0) controlling channel 7 - bank 1 setup for Rescue Mode on same 3 position switch(position 1) controlling channel 7 - I want bank 2 to select Return to Home on same 3 position switch(position 2) controlling channel 7 but the Spirit Setting software will not allow me to do this. Since I have used up all my transmitter channels, how to I select Return to Home without another transmitter channel? Thanks Don |
|
| Author: | andy6409 [ Mon 09. Dec 2019 17:38:05 ] |
| Post subject: | Re: Spirit Pro/Geolink Setup with DX8 |
you could free up channel 5 by putting your tail gyro setting directly in the Spirit unit instead of TX then assign a geolink function to channel 5 Other than that you need new TX |
|
| Author: | DonHoutz [ Tue 10. Dec 2019 15:25:14 ] |
| Post subject: | Re: Spirit Pro/Geolink Setup with DX8 |
Yes, that is what I determined, so I had a Spektrum IX12 and began to re-setup the Spirit Pro on this transmitter. Well, while setting up everything, the Spirit Settings software hung up and I had to kill it from my PC and power cycle the Spirit Pro. After powerup, now I cannot get the Spirit Pro to connect to the Geolink. I also noticed the Spirit Pro serial number is ff-ff-ff-ff-ff-1 which is not what it used to be. And finally, the Spirit Pro is not performing any gyro corrections when I tilt the heli. It does talk to the transmitter and the servos move correctly when commanded from the transmitter. Seems like something happened to the Spirit Pro when I powercycled? I tried just about everything but no fixes. I tried reflashing the firmware(2.7.1) which went ok, but it did not correct any of the issues. What should I do? Tomas: I sent you several personal emails about this. Can you respond to the them? Thanks Don |
|
| Author: | ZeXx86 [ Tue 10. Dec 2019 21:13:53 ] |
| Post subject: | Re: Spirit Pro/Geolink Setup with DX8 |
Hello, reply was sent to your email. I believe it will be sorted easily. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|