hi Thomas
the ratio in fact is 1:1 because is a direct drive helicopter
the motor is coaxial to the main shaft
anyway seem the correct parameter is to put
sensing divider: 12
gear ratio: 1.00
| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Goblin 280 and Telemetry https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3644 |
Page 1 of 1 |
| Author: | Kiwi1970 [ Wed 20. Nov 2019 12:20:01 ] |
| Post subject: | Goblin 280 and Telemetry |
Hallo togehter! I'm trying to set the telemetry on my Goblin 280. In the tab for the gear ratio I would have to enter 1: 1, but this will not be saved. Can someone tell me what I have to enter here for the right configuration? Thank you and best regards Robert |
|
| Author: | ZeXx86 [ Wed 20. Nov 2019 12:43:45 ] |
| Post subject: | Re: Goblin 280 and Telemetry |
Hello, you should just enter what is stated in the Goblin manual. Then save the settings and all will be OK. For sure correct ratio is not 1 : 1 for this model. |
|
| Author: | urgno [ Wed 20. Nov 2019 22:01:07 ] |
| Post subject: | Re: Goblin 280 and Telemetry |
hi Thomas the ratio in fact is 1:1 because is a direct drive helicopter the motor is coaxial to the main shaft anyway seem the correct parameter is to put sensing divider: 12 gear ratio: 1.00
|
|
| Author: | ZeXx86 [ Thu 21. Nov 2019 8:21:26 ] |
| Post subject: | Re: Goblin 280 and Telemetry |
Yes, you are right. I forgot to mention Sensing Divider because this is configured according the motor poles. |
|
| Author: | Kiwi1970 [ Thu 21. Nov 2019 10:55:50 ] |
| Post subject: | Re: Goblin 280 and Telemetry |
Thanks to both of you. this information helped me. Best regards Robert |
|
| Author: | urgno [ Thu 21. Nov 2019 16:21:25 ] |
| Post subject: | Re: Goblin 280 and Telemetry |
no worries enjoy your flights 
|
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|