Thanks a lot
| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Spirit Pro Mounting Tolerances on the axes to the Frame https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3617 |
Page 1 of 1 |
| Author: | ripcurl777 [ Thu 24. Oct 2019 9:02:03 ] |
| Post subject: | Spirit Pro Mounting Tolerances on the axes to the Frame |
I know the unit has to be in perfect alignment to the Helis Frame / Main shaft on all Axes. I plan to put it on a 3D printet mount where normally the Battery is located on a Trex 500. So is there any tolerance in the angle or has it to be dead Spot to the Main shaft in all axes? Thanks |
|
| Author: | ZeXx86 [ Thu 24. Oct 2019 9:04:08 ] |
| Post subject: | Re: Spirit Pro Mounting Tolerances on the axes to the Frame |
1° tollerance is usually fine. It will fly even if mounted 10° off, but of course it is not good for performance. |
|
| Author: | ripcurl777 [ Thu 24. Oct 2019 13:26:21 ] |
| Post subject: | Re: Spirit Pro Mounting Tolerances on the axes to the Frame |
Thanks a lot
|
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|