|
It is currently Sun 24. Nov 2024 22:53:46
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
ripcurl777
|
 Posted: Thu 24. Oct 2019 9:02:03 |
|
Joined: Thu 24. Oct 2019 8:56:14
Posts: 5
|
|
I know the unit has to be in perfect alignment to the Helis Frame / Main shaft on all Axes.
I plan to put it on a 3D printet mount where normally the Battery is located on a Trex 500.
So is there any tolerance in the angle or has it to be dead Spot to the Main shaft in all axes?
Thanks
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Thu 24. Oct 2019 9:04:08 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
1° tollerance is usually fine.
It will fly even if mounted 10° off, but of course it is not good for performance.
_________________
Spirit System developer
|
|
| Top |
|
|
|
ripcurl777
|
Posted: Thu 24. Oct 2019 13:26:21 |
|
Joined: Thu 24. Oct 2019 8:56:14
Posts: 5
|
Thanks a lot 
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 76 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
