| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Safe to connect System Interface with FrSky integration? https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3612 |
Page 1 of 1 |
| Author: | xoexoe [ Mon 21. Oct 2019 22:02:55 ] |
| Post subject: | Safe to connect System Interface with FrSky integration? |
I am using 3 different Spirit units: • Spirit Black with R-XSR receiver • micro Spirit with XSR receiver • Spirit 2 with R-XSR receiver All have integration and telemetry enabled via FrSky Horus OpenTX. All have a FrSky integration cable connected between the SYS port and the receiver's S.Port. If I want to connect the USB programming interface connector to my units (because I'd rather do some particular setup using computer than using integration), I need to access the SYS port. But the SYS port is occupied with integration cables. Here's my question: Is it safe electronically for me to make a simple Y-connector so that during setup on my computer I simultaneously have the SYS port connected to my computer's USB drive and keep the FrSky integration cable connected to the SYS port? Usually I physically disconnect the FrSKy integration cable when I want to connect to a computer, but I'm wondering if it's safe to just keep it connected. If I do so then the USB programming cable would be in parallel with the FrSky integration cable and with all S.Port sensors. I would be powering the unit with my HobbyWing bulit-in ESC via Aux or Aux 1 port. |
|
| Author: | xoexoe [ Fri 25. Oct 2019 6:20:26 ] |
| Post subject: | Re: Safe to connect System Interface with FrSky integration? |
Is this safe? |
|
| Author: | ZeXx86 [ Fri 25. Oct 2019 7:10:28 ] |
| Post subject: | Re: Safe to connect System Interface with FrSky integration? |
Hello, it is not safe unfortunately and also it will not work when connected at the same time. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|