| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| SBUS, S Port @ 7.4V https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3396 |
Page 1 of 1 |
| Author: | hefeweizen [ Thu 18. Jul 2019 15:24:33 ] |
| Post subject: | SBUS, S Port @ 7.4V |
Hi, I'm building up a heli with 7.4V servos. I plan to use an Frsky receiver (R4XR or R-XSR). I'm planing to use a Spirit (non pro) with the SBUS inverter cable and S Port integration cable sold on the spirit website. If I don't do anything special, these integration cables will have 7.4V on VDD. Is this a supported setup? |
|
| Author: | enied [ Fri 19. Jul 2019 10:37:28 ] |
| Post subject: | Re: SBUS, S Port @ 7.4V |
As far as I know is the signal voltage much lower than the power settings for your HV heli. So it should be supported. Best Regards, Eugen |
|
| Author: | ZeXx86 [ Fri 19. Jul 2019 12:11:19 ] |
| Post subject: | Re: SBUS, S Port @ 7.4V |
Yes, without any problem. I highly recommmend to not use R-XSR or similar small receivers for other than micro models. Receivers with a standard servo connectors will be much better. |
|
| Author: | hefeweizen [ Fri 19. Jul 2019 15:10:27 ] |
| Post subject: | Re: SBUS, S Port @ 7.4V |
Thank you. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|