Thanks so much for your prompt reply
Greets , Robert
| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Govenor Servo https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3394 |
Page 1 of 1 |
| Author: | speed kills [ Wed 17. Jul 2019 16:05:55 ] |
| Post subject: | Govenor Servo |
Hello Tomas, I would like to use a Tail-Servo (760µs/333-560Hz) as Govenor-Servo for my Nitro-Heli. Is there a way to change this in the Govenor-Settings? But I guess without a new firmware it's not possible? Are you planing to make a new firmware? Best whishes, Robert |
|
| Author: | urgno [ Wed 17. Jul 2019 17:05:06 ] |
| Post subject: | Re: Govenor Servo |
not sure will make any difference maybe nitro engine is not able to follow a servo so fast |
|
| Author: | ZeXx86 [ Wed 17. Jul 2019 17:10:31 ] |
| Post subject: | Re: Govenor Servo |
Hello, you can use only 1520µs servos for Throttle. In the future 760µs is planned. |
|
| Author: | speed kills [ Wed 17. Jul 2019 17:15:08 ] |
| Post subject: | Re: Govenor Servo |
Thanks so much for your prompt reply Greets , Robert |
|
| Author: | speed kills [ Mon 22. Jul 2019 14:10:36 ] |
| Post subject: | Re: Govenor Servo |
Hello, Today I tested the Graupner Servo 770 HBS as a Govenor-Servo in my Goblin 650 Nitro. The servo runs with 1520μs and is actually intended as a rear servo. I was really surprised how fast and well the Govenor works now. Throttle response is prompt and the rpm is fantastic stable. I think a 760μs servo will work even better, and I hope there will be soon a new soft,-and firmware, so I can use a fast tail servo 
|
|
| Author: | ZeXx86 [ Sat 27. Jul 2019 8:57:18 ] |
| Post subject: | Re: Govenor Servo |
Thank you for the message! Yes, the support will be included soon. But 760us are not always faster than 1520us. But usually just tail servos are 760us. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|