| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Mapping rescue to switch on Futaba Tx? https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3385 |
Page 1 of 1 |
| Author: | John tan [ Mon 08. Jul 2019 16:17:51 ] |
| Post subject: | Mapping rescue to switch on Futaba Tx? |
I have a Futaba T8J & Spirit. Can anyone explain to me how to map rescue to a switch on the Tx? |
|
| Author: | andy6409 [ Mon 08. Jul 2019 19:21:47 ] |
| Post subject: | Re: Mapping rescue to switch on Futaba Tx? |
In Spirit software - General tab - channels - assign F stabi function to either channel 7 or 8 In TX aux channel page assign your rescue switch to the channel you selected You can test it in the channels tab ( State on or off ) |
|
| Author: | John tan [ Mon 08. Jul 2019 20:21:41 ] |
| Post subject: | Re: Mapping rescue to switch on Futaba Tx? |
andy6409 wrote: In Spirit software - General tab - channels - assign F stabi function to either channel 7 or 8 In TX aux channel page assign your rescue switch to the channel you selected You can test it in the channels tab ( State on or off ) Do you need to set gyro to negative in order for rescue to work? |
|
| Author: | andy6409 [ Tue 09. Jul 2019 17:09:12 ] |
| Post subject: | Re: Mapping rescue to switch on Futaba Tx? |
No, not when you assign a channel for rescue Negative gyro is the original way of doing it, assigned channel is much easier |
|
| Author: | John tan [ Tue 09. Jul 2019 20:49:02 ] |
| Post subject: | Re: Mapping rescue to switch on Futaba Tx? |
I followed your instructions and did it... so happy  I also set the rescue timing to 0.5 secs, which I think gives the heli enough time to ascend and recover properly. The default 0.1 sec is too fast I think. Will be testing it out this weekend. Hope it all goes well. Thanks Andy. Couldn't have done it without your help. |
|
| Author: | andy6409 [ Tue 09. Jul 2019 21:06:35 ] |
| Post subject: | Re: Mapping rescue to switch on Futaba Tx? |
The rescue timing (acro delay) is just the delay between activating rescue and flipping skids down using rescue normal. It will level out and climb inverted first if it is nearer that attitude Rescue acro goes to the nearest attitude i.e skids up or down and stays there If not using a spring loaded switch the Spirit will stay in rescue mode and keep climbing until you deactivate the switch |
|
| Author: | John tan [ Thu 11. Jul 2019 0:54:20 ] |
| Post subject: | Re: Mapping rescue to switch on Futaba Tx? |
Got it
|
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|