|
It is currently Mon 25. Nov 2024 2:57:41
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 4 posts ] |
|
| Author |
Message |
|
jaffrie
|
 Posted: Sat 22. Jun 2019 14:44:35 |
|
Joined: Mon 19. Dec 2016 17:14:43
Posts: 21
|
|
Hi Guy,
Need some advice. Been awhile since I last did a new build. Completed set-up with Jeti Tx & Spirit Pro
on Sab Havok 280. During cyclic ring set up servos was moving pretty fast so everything work ok but
after completed set up & re power up the heli cyclic servos are moving at about half the speed. Guess
I must have miss something, would appreciate some help. Tx swash set to mechanical, Rx 3 connected via
Ex Bus on E2 .
Thanks in advance
|
|
| Top |
|
 |
|
jaffrie
|
Posted: Sun 23. Jun 2019 9:46:46 |
|
Joined: Mon 19. Dec 2016 17:14:43
Posts: 21
|
|
| Top |
|
|
|
jaffrie
|
Posted: Sun 23. Jun 2019 16:37:31 |
|
Joined: Mon 19. Dec 2016 17:14:43
Posts: 21
|
|
Problem discovered & solved
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Mon 24. Jun 2019 7:29:34 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
The behavior you are describing is very normal and everything is correct.
It should not move fast actually since it is not flybar. With no model response to a commands the behavior is just different than in the air.
It is important how it feels in the flight not on the bench. Depending on this you should make an adjustments.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 82 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
