| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Governor with uspirit https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3293 |
Page 1 of 1 |
| Author: | Tgilf [ Wed 01. May 2019 20:55:28 ] |
| Post subject: | Governor with uspirit |
How can I connect the hobbywing platinum esc 25a v4 to my uSpirit? The esc has a one cable yellow normal servo plug which should be rpm. With receiver connected and esc (throttle) connected to uspirit I don’t have any jst Adapter left, . How is this meant to be done? Thanks Tom |
|
| Author: | xokia [ Thu 02. May 2019 2:32:59 ] |
| Post subject: | Re: Governor with uspirit |
The yellow wire has to connect to the pitch pin of the P/E/A pins. You can either get a JST connector and cut it then solder the RPM wire to that wire. -> this is what I did because I did not want a giant mess of wires. Oxy 2 I assume? I had the exact same setup. Or plug the RPM wire into a JST servo adapter. Make sure it lines up with the Pitch pin. I had telemetry and ext gov on my Oxy 2. To many wires for very little benefit IMO. The ext gov works but I did not find it any better than the internal gov. I actually preferred the internal gov of the hobbywing. Just my $.02 |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|