|
It is currently Mon 25. Nov 2024 6:28:55
|
View unanswered posts | View active topics
|
Page 1 of 1
|
[ 2 posts ] |
|
Author |
Message |
Tgilf
|
Posted: Wed 01. May 2019 20:55:28 |
|
Joined: Mon 08. Apr 2019 6:13:04 Posts: 15
|
How can I connect the hobbywing platinum esc 25a v4 to my uSpirit? The esc has a one cable yellow normal servo plug which should be rpm. With receiver connected and esc (throttle) connected to uspirit I don’t have any jst Adapter left, . How is this meant to be done? Thanks Tom
|
|
Top |
|
|
xokia
|
Posted: Thu 02. May 2019 2:32:59 |
|
Joined: Sun 10. Feb 2019 7:10:27 Posts: 74
|
The yellow wire has to connect to the pitch pin of the P/E/A pins.
You can either get a JST connector and cut it then solder the RPM wire to that wire. -> this is what I did because I did not want a giant mess of wires. Oxy 2 I assume? I had the exact same setup.
Or plug the RPM wire into a JST servo adapter. Make sure it lines up with the Pitch pin.
I had telemetry and ext gov on my Oxy 2. To many wires for very little benefit IMO. The ext gov works but I did not find it any better than the internal gov. I actually preferred the internal gov of the hobbywing. Just my $.02
|
|
Top |
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
|
Who is online |
|
Users browsing this forum: Bing [Bot] and 44 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|