hi, need some help, please
I am trying to set up a T-REX 600 nitro. With spirit pro and geolink. am using Futaba and S.BUS. 18ch
on channel 5 got rescue on a negative value.
on channel 8 with altitude hold
on channel 9 with position hold
on channel 10 with altitude limit.
Today I tried my helicopter and while been in the air, I have switched CH8 on to activate altitude hold...
the helicopter was going up and down and advice to reduce the vertical gain so I reduced the vertical gain, from 80% down to 60%
on 60% the helicopter was still going up and down like before so I decided to go to 55%
On 55% on altitude hold was not doing much on the first position where I can control the pitch, so I use the second position with no pitch control and the helicopter was going UP very fast.
I try again to change setting so I disable the altitude limit, try again with 50% altitude hold, and on the first position was no doing nothing and in the second one, the helicopter went down, very fast and crash, I was not able to do nothing to avoid the crash as was going to fast down, and by the time I disable altitude hold I was already on the floor.... a very bad crash
any help to discover what happened, please!!
got the files of the crash.
is there something am missing with the setup of altitude limit?
anyone with more experience can help me, please. I just need an easy setup with altitude hold and position.
| Attachments: |
spirit setings 03.04.19.4ds [255 Bytes]
Downloaded 28 times |
|
log crash 03.04.19.4dl [2.82 KiB]
Downloaded 33 times |