| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Governor Settings https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3194 |
Page 1 of 1 |
| Author: | eric303 [ Tue 05. Mar 2019 5:07:34 ] |
| Post subject: | Governor Settings |
I am having issues trying to set the max head speed below 1500rpm...I am trying to set it too 1200rpm for low headspeed. The motor I have is a Scorpion HK-II-4525-520kv. Sensing Divide set to 5. Gear radio 11.9. Speed controller is Hobbywing 200A V4.1. Throttle range Min 1000us max 1900us. Also any recommendations for the throttle curve to get started? I have a JETI-DS16. |
|
| Author: | ryguy76 [ Tue 05. Mar 2019 5:15:45 ] |
| Post subject: | Re: Governor Settings |
Your Max can stay at 1500rpm. From there, set your throttle curves in radio to give you 1200rpm. 1200/1500 = 0.8. 80% TC should give you 1200rpm. Sent from my iPhone using Tapatalk |
|
| Author: | ZeXx86 [ Tue 05. Mar 2019 8:49:55 ] |
| Post subject: | Re: Governor Settings |
Correct, you should use flat throttle curve at 80% to get 1200 RPM. You can verify it by looking at the Governor window. There you can see Requested RPM if you will disarm the Throttle Hold for a short period of time. |
|
| Author: | eric303 [ Wed 06. Mar 2019 5:41:13 ] |
| Post subject: | Re: Governor Settings |
Thanks for the info. I set curve to 80%...During bench testing with no blades it reached 1000rpm and the RPM sensor test signal was flashing from active to inactive rapidly...is this due to the lack of load? |
|
| Author: | ZeXx86 [ Wed 06. Mar 2019 7:59:00 ] |
| Post subject: | Re: Governor Settings |
Yes, when there is no load it might not reach the requested RPM precisely. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|