| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| No RX voltage https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3146 |
Page 1 of 1 |
| Author: | xokia [ Sun 10. Feb 2019 7:49:09 ] |
| Post subject: | No RX voltage |
I have the 4649T receiver and a talon 25 connected to an oxy3. I have an iX12 transmitter. I have gotten all the telemetry to work but I do not get RX voltage. I read that the 4649T doesnt send this value on its own. It either has to come from the ESC or the FBL controller. I dont think the Talon 25 send the BEC voltage as telemetry. Can the Spirit send this voltage somehow? |
|
| Author: | ZeXx86 [ Sun 10. Feb 2019 22:35:00 ] |
| Post subject: | Re: No RX voltage |
Hello, you have to connect pin from the SPM4649T receiver at the BEC. This pin is sensing voltage - it is wired out in the second (normally unused) connector. Talon is sending the value as far as we know. So actually it should be visible as the BEC [V] at the ESC status page. This mean that if the ESC is supporting this, the Spirit unit will send it. |
|
| Author: | xokia [ Mon 11. Feb 2019 1:20:07 ] |
| Post subject: | Re: No RX voltage |
ZeXx86 wrote: Talon is sending the value as far as we know. So actually it should be visible as the BEC [V] at the ESC status page. This mean that if the ESC is supporting this, the Spirit unit will send it. I am not sure the Talon 35 is sending the BEC voltage as telemetry data I sent a note to castle creation to find out. I believe the voltage sense port is for main pack voltage correct? If I use that to sense BEC voltage I think it will override the Talon ESC main voltage data. |
|
| Author: | ZeXx86 [ Mon 11. Feb 2019 8:12:06 ] |
| Post subject: | Re: No RX voltage |
The SPM4649T port has uncoupled telemetry with ESC. So you can use the measurement port for anything you like - BEC or main battery voltage or just one cell. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|