Hi,
My Helicopter is a Trex 500X with a Spirit Pro and Geolink Module. I have set bank 0 to normal stabilisation, bank 1 to coaxial stabilisation and bank 2 to rescue normal. With bank 1 (coaxial) selected, when I change to bank 2 rescue normal (with mixing/momentary switch) it seems to behave normally. It changes from -6 pitch (with lowest collective stick position) to +6 pitch.
With bank 0 selected (stabilisation normal), when I change to bank 2 the pitch only changes from -12 to -6.
When connected to the Spirit software With bank 0 selected (stabilisation normal), when I change to bank 2 the pitch changes from -12 to +6. I have saved the settings to the unit's memory and everything else seems to be working normally. Not sure why it behaves as I would expect only when connected.
Thanks
Grant
I must be missing something fundamental. I have reloaded the firmware and run through the setup again but still get the same result. Rescue (bank 2) only works from stabilisation normal (bank 0) when I am connected to the Spirit software with the diagnostic tab open. When disconnected, the collective pitch doesn't change when collective is at 0 degrees and from collective -12 degrees it moves to -6 degrees. Same result whether I connect with USB or Wifi. I would be grateful if anyone has any ideas. I am using firmware version 2.6.1.4 and software version 2.6.1. Thanks.
| Attachments: |
Trex500x rev1.4ds [255 Bytes]
Downloaded 49 times |