|
It is currently Sun 24. Nov 2024 18:00:45
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 5 posts ] |
|
| Author |
Message |
|
Franky13
|
 Posted: Thu 31. Jan 2019 15:38:48 |
|
Joined: Tue 30. Dec 2014 7:50:36
Posts: 135
|
|
Hello!
How do I connect the new YGE 205 HVT with BEC to the SpiritPro?
The YGE protocol is also intended for the Spirtit FBL-System!
Jeti EX Bus is possible.
My equipment:
REX3, SpiritPro and YGE 205HVT with BEC
Photo attached.
Thank you!
Greeting Frank
| Attachments: |
YGE.jpeg [ 1.93 MiB | Viewed 328 times ]
|
|
|
| Top |
|
 |
|
Franky13
|
Posted: Fri 01. Feb 2019 22:04:00 |
|
Joined: Tue 30. Dec 2014 7:50:36
Posts: 135
|
|
Nobody a suggestion. Or maybe tomas?
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Fri 01. Feb 2019 22:16:42 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
If possible, combine BEC cable and Throttle signal into one cable - primary.
Second cable will be just for BEC - secondary.
This will allow having just two cables instead of 3.
Then connect primary cable at the AUX1 and secondary at the AUX2 port and all will be fine.
Telemetry can be connected in a way you wish - to JETI receiver or Spirit unit.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Franky13
|
Posted: Sun 03. Feb 2019 11:19:12 |
|
Joined: Tue 30. Dec 2014 7:50:36
Posts: 135
|
|
Ok, thanks!
I then put the receiver signal cable in the BEC cable.
The minus cable (from the receiver) too, or "disconnect"?
Then the new BEC cable in AUX1!
Greeting
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Mon 04. Feb 2019 8:27:30 |
|
|
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
It should be enough to use GND (-) from BEC connector. So Receiver GND will be unused.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 5 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: Flapflap and 84 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
