Spirit System • View topic - Wizard setup - Model Presets are grayed out (not selectable)

It is currently Sun 24. Nov 2024 17:57:39

View unanswered posts | View active topics

Board index » English » HELI » Support

All times are UTC + 1 hour

Wizard setup - Model Presets are grayed out (not selectable)

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

Bladecrasher

Post subject: Wizard setup - Model Presets are grayed out (not selectable)

Posted: Mon 04. Feb 2019 8:29:01

Joined: Wed 16. Mar 2016 15:58:50
Posts: 98

I'm setting up a Oxy3 Qube and when I stepped through the Wizard and got to the Oxy3 listing, it would not allow me to select it?

Does the size of the unit (Pro, Reg, uSpirit) have any factor in this? I'm using a uSpirit since it's not installed presently.

The computer software shows 2.5.0. When connected, I believe the unit shows 2.5.1.

I could select Oxy2 though, which I did to continue the binding process. I now realize that was an error since the Elev servo is not in the same location. Should I just manually make the other adjustments or re-try the Wizard with a model that has the Elev servo in front of the main shaft?

Top

ZeXx86

Post subject: Re: Wizard setup - Model Presets are grayed out (not selecta

Posted: Mon 04. Feb 2019 8:34:25

Site Admin

Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442

Hello,

it is dependent on the unit. Oxy 3 preset is available rather for Spirit and Spirit Pro units. So you are right it is due to size.
But you can freely use Oxy 2 preset and it will work in the same way.

_________________
Spirit System developer

Top

Page 1 of 1

[ 2 posts ]

Board index » English » HELI » Support

All times are UTC + 1 hour

Who is online

Users browsing this forum: Flapflap, Helihello and 76 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: