|
It is currently Sun 24. Nov 2024 19:40:36
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
Bladecrasher
|
 Posted: Mon 04. Feb 2019 8:29:01 |
|
Joined: Wed 16. Mar 2016 15:58:50
Posts: 98
|
|
I'm setting up a Oxy3 Qube and when I stepped through the Wizard and got to the Oxy3 listing, it would not allow me to select it?
Does the size of the unit (Pro, Reg, uSpirit) have any factor in this? I'm using a uSpirit since it's not installed presently.
The computer software shows 2.5.0. When connected, I believe the unit shows 2.5.1.
I could select Oxy2 though, which I did to continue the binding process. I now realize that was an error since the Elev servo is not in the same location. Should I just manually make the other adjustments or re-try the Wizard with a model that has the Elev servo in front of the main shaft?
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Mon 04. Feb 2019 8:34:25 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hello,
it is dependent on the unit. Oxy 3 preset is available rather for Spirit and Spirit Pro units. So you are right it is due to size.
But you can freely use Oxy 2 preset and it will work in the same way.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: The Gasman and 65 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
