| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| New YGE 205 HVT with BEC https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3123 |
Page 1 of 1 |
| Author: | Franky13 [ Thu 31. Jan 2019 15:38:48 ] | ||
| Post subject: | New YGE 205 HVT with BEC | ||
Hello! How do I connect the new YGE 205 HVT with BEC to the SpiritPro? The YGE protocol is also intended for the Spirtit FBL-System! Jeti EX Bus is possible. My equipment: REX3, SpiritPro and YGE 205HVT with BEC Photo attached. Thank you! Greeting Frank
|
|||
| Author: | Franky13 [ Fri 01. Feb 2019 22:04:00 ] |
| Post subject: | Re: New YGE 205 HVT with BEC |
Nobody a suggestion. Or maybe tomas? |
|
| Author: | ZeXx86 [ Fri 01. Feb 2019 22:16:42 ] |
| Post subject: | Re: New YGE 205 HVT with BEC |
If possible, combine BEC cable and Throttle signal into one cable - primary. Second cable will be just for BEC - secondary. This will allow having just two cables instead of 3. Then connect primary cable at the AUX1 and secondary at the AUX2 port and all will be fine. Telemetry can be connected in a way you wish - to JETI receiver or Spirit unit. |
|
| Author: | Franky13 [ Sun 03. Feb 2019 11:19:12 ] |
| Post subject: | Re: New YGE 205 HVT with BEC |
Ok, thanks! I then put the receiver signal cable in the BEC cable. The minus cable (from the receiver) too, or "disconnect"? Then the new BEC cable in AUX1! Greeting |
|
| Author: | ZeXx86 [ Mon 04. Feb 2019 8:27:30 ] |
| Post subject: | Re: New YGE 205 HVT with BEC |
It should be enough to use GND (-) from BEC connector. So Receiver GND will be unused. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|