|
It is currently Mon 25. Nov 2024 5:50:28
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
George Baker
|
 Posted: Fri 25. Jan 2019 16:26:41 |
|
Joined: Thu 12. May 2016 0:20:26
Posts: 81
|
|
Using Spirit on my gas helicopter. The throttle channel servo is connected to the Spektrum receiver not the Spirit.
-Before takeoff, if I shut off the gas engine so there is zero vibration, and I don't move any controls, will the rescue function of the Spirit calibrate itself again if it was not level?
-How long would it take?
-Does the Spirit monitor the throttle channel for the purpose of level calibration to see if the model is flying or on ground?
Thanks
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Mon 28. Jan 2019 9:27:09 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hello,
1. Yes, it will start to level immediately when model is motionless with motor off.
2. It could take up to 20 seconds depending on error that was present.
3. No, only vibrations/motion are sensed, so throttle channel has no effect.
_________________
Spirit System developer
|
|
| Top |
|
|
|
George Baker
|
Posted: Mon 28. Jan 2019 15:41:40 |
|
Joined: Thu 12. May 2016 0:20:26
Posts: 81
|
|
Thank you Tomas; that is good news. I didn't understand how this worked before and I've been incorrectly turning the electrics of the helicopter off and then back on again to "re-calibrate" the rescue. I didn't need to do that. Thanks again for the helpful information.
Regards,
George
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 46 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
