Spirit System
https://www.spirit-system.com/phpBB3/

[SOLVED] No telemetry values (Jeti REX3 + HobbyWing v4 Opto)
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3116		 Page 1 of 1
Author:  olibanjoli [ Sat 26. Jan 2019 13:13:12 ]
Post subject:  [SOLVED] No telemetry values (Jeti REX3 + HobbyWing v4 Opto)
Hi

I used a Spirit Pro unit with a Frsky X8R receiver and a Hobbywing 130A v4 Opto ESC. Telemetry and integration was working perfectly.

I switched to Jeti DS16 using a REX3 receiver. I connected everything according to the Jeti Integration wiki page. I can configure the Spirit unit from my TX. But i never receive any telemetry values from the ESC. All the sensors are discovered but i never get any value.

I'm not able to find the mistake i made. Do you have any ideas what could went wrong?

Regards
oli
Author:  ZeXx86 [ Sun 27. Jan 2019 20:37:24 ]
Post subject:  Re: No telemetry values (Jeti REX3 + HobbyWing 130a v4 Opto)
Hi,

probably you are in the Configuration mode - the Status LED of the uni tis flashing.
You have to close the integration menu if it was entered previously.
Author:  olibanjoli [ Sat 02. Feb 2019 19:18:39 ]
Post subject:  Re: No telemetry values (Jeti REX3 + HobbyWing 130a v4 Opto)
No im not in configuration mode. I double checked that.
Author:  olibanjoli [ Sun 03. Feb 2019 14:40:45 ]
Post subject:  Re: No telemetry values (Jeti REX3 + HobbyWing 130a v4 Opto)
found the mistake :roll:

i also turned the spirit unit 180° when i switched to jeti receiver. so the telemetry cable from the hobbywing esc was not in the primary satelite port :(. turned it back and telemetry is working properly :D
Author:  ZeXx86 [ Mon 04. Feb 2019 8:24:59 ]
Post subject:  Re: No telemetry values (Jeti REX3 + HobbyWing 130a v4 Opto)
Very well :) Sometimes these issues are happening.
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/