| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Calibration question https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3114 |
Page 1 of 1 |
| Author: | George Baker [ Fri 25. Jan 2019 16:26:41 ] |
| Post subject: | Calibration question |
Using Spirit on my gas helicopter. The throttle channel servo is connected to the Spektrum receiver not the Spirit. -Before takeoff, if I shut off the gas engine so there is zero vibration, and I don't move any controls, will the rescue function of the Spirit calibrate itself again if it was not level? -How long would it take? -Does the Spirit monitor the throttle channel for the purpose of level calibration to see if the model is flying or on ground? Thanks |
|
| Author: | ZeXx86 [ Mon 28. Jan 2019 9:27:09 ] |
| Post subject: | Re: Calibration question |
Hello, 1. Yes, it will start to level immediately when model is motionless with motor off. 2. It could take up to 20 seconds depending on error that was present. 3. No, only vibrations/motion are sensed, so throttle channel has no effect. |
|
| Author: | George Baker [ Mon 28. Jan 2019 15:41:40 ] |
| Post subject: | Re: Calibration question |
Thank you Tomas; that is good news. I didn't understand how this worked before and I've been incorrectly turning the electrics of the helicopter off and then back on again to "re-calibrate" the rescue. I didn't need to do that. Thanks again for the helpful information. Regards, George |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|