Hi,
If I disconnect the motor wires voltage is not transmitted. I done it for testing.
Until I reconnect the motor correctly main voltage is there. Interesting but so seems not a big problem then. But did not know it before.Cheers,
Nils
| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| [SOLVED] New Sbus Telemetry 2.6.0 - how to setup? https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3023 |
Page 1 of 1 |
| Author: | augur [ Thu 13. Dec 2018 22:11:11 ] |
| Post subject: | [SOLVED] New Sbus Telemetry 2.6.0 - how to setup? |
Hi, there was a note that the telemetry changed for Sbus or Fasstest. But I cannot find anything about it and also it does not work with old configuration. So how it has to be setup? Cheers, Nils |
|
| Author: | ZeXx86 [ Thu 13. Dec 2018 23:29:42 ] |
| Post subject: | Re: New Sbus Telemetry 2.6.0 - how to setup? |
There is nothing different in the FASSTest telemetry. It has only better compatibility. It is identical with 2.5.2 regarding setup. |
|
| Author: | augur [ Fri 14. Dec 2018 0:39:09 ] |
| Post subject: | Re: New Sbus Telemetry 2.6.0 - how to setup? |
Ok. Many values are not transmitted anymore as with my T18MZ before it now changed equal to my T14sg. Will prepare an example tomorrow. Cheers Nils |
|
| Author: | augur [ Fri 14. Dec 2018 14:23:54 ] |
| Post subject: | Re: New Sbus Telemetry 2.6.0 - how to setup? |
Hi, If I disconnect the motor wires voltage is not transmitted. I done it for testing. Until I reconnect the motor correctly main voltage is there. Interesting but so seems not a big problem then. But did not know it before.Cheers, Nils |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|