Hi,
thank you for your message. You are good engineer
| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| [SOLVED] Governor sensor https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=2880 |
Page 1 of 1 |
| Author: | kgnkazanci [ Sun 07. Oct 2018 12:23:58 ] |
| Post subject: | [SOLVED] Governor sensor |
Hi there, I could not fly today due to governor sensor failure,I've been using Align gov sensor for Spirit fbl governor for a while, I think it's a hall sensor since it works with magnets. Here is my question comes, I need sensor immediately, if I try to use a simple hall sensor like US1881 Hall Effect Sensor, does it work? |
|
| Author: | kgnkazanci [ Thu 11. Oct 2018 20:53:12 ] |
| Post subject: | Re: Governor sensor |
Hi, I've bought super cheap US1881 hall effect sensor from a local electronic store, Soldered according to it's datasheet, powered from receiver directly due to min 4.5vdc power requirement, So far so good, it works better than original, I have more stable rpm readouts now, ciao |
|
| Author: | ZeXx86 [ Fri 12. Oct 2018 7:57:25 ] |
| Post subject: | Re: Governor sensor |
Hi, thank you for your message. You are good engineer
|
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|