| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Difference 6 degrees geometry to 4.5 in TDF ...? https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=2855 |
Page 1 of 1 |
| Author: | Franky13 [ Wed 26. Sep 2018 17:22:49 ] |
| Post subject: | Difference 6 degrees geometry to 4.5 in TDF ...? |
Hi Tomas! Please explain to me why the 6 degree geometry should be set to 4.5 on TDF. What is better at 4.5 Geometry, what are the positive effects of the change in TDF? Or can adjust other parameters to get the same effect? Thanks for answer! Greeting Frank |
|
| Author: | ZeXx86 [ Thu 27. Sep 2018 8:04:17 ] |
| Post subject: | Re: Difference 6 degrees geometry to 4.5 in TDF ...? |
Hi, TDF has not standard geometry and because Geometry 6° is counting with standard geometry it require different configuration for linear servo travel. If value is too high then you will get unwanted oscillations and problems with elevator. No, you can't achieve same settings with other parameters. |
|
| Author: | mb-1953 [ Thu 27. Sep 2018 12:30:57 ] |
| Post subject: | Re: Difference 6 degrees geometry to 4.5 in TDF ...? |
Would this also apply to the tdr2, which also uses linear linkage. |
|
| Author: | ZeXx86 [ Sun 30. Sep 2018 18:01:26 ] |
| Post subject: | Re: Difference 6 degrees geometry to 4.5 in TDF ...? |
Yes |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|