| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Geo-Link is not connected after update https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=2852 |
Page 1 of 1 |
| Author: | speed kills [ Tue 25. Sep 2018 17:53:24 ] |
| Post subject: | Geo-Link is not connected after update |
Hello, After updating geo-link to fw-1.0.2 the software spirit 2.5.2.shows me after rebooting,that the geo-link is not connected,and blue LED blinks for a while,but than it turns off. I tried to flash in recovery mode,but after doing this I get the message : update failed. So what can I do ??? Greetings,Robert |
|
| Author: | ZeXx86 [ Tue 25. Sep 2018 17:57:12 ] |
| Post subject: | Re: Geo-Link is not connected after update |
Hello, either the Spirit unit is not updated to 2.5.2 or the GeoLink is in calibration mode. Is it flashing or it is steady on for a while - after power up? |
|
| Author: | speed kills [ Tue 25. Sep 2018 18:06:20 ] |
| Post subject: | Re: Geo-Link is not connected after update |
I've updatet my Spirit to 2.5.2 and when I power up the blue LED on Geo-Link is flashing quiet different,and than it turns off. But when I move the Geo-Link the LED flashes a short time,and than it turns off again. The Spirit-Settings show me,that Geo-Link is not connected. |
|
| Author: | ZeXx86 [ Tue 25. Sep 2018 18:15:20 ] |
| Post subject: | Re: Geo-Link is not connected after update |
In that case your GeoLink is in the calibration mode and it is normal behavior. This behavior is always occurring when you click at the Compass Calibration button in the Spirit Settings. |
|
| Author: | speed kills [ Tue 25. Sep 2018 18:41:15 ] | ||||
| Post subject: | Re: Geo-Link is not connected after update | ||||
I've been waiting for over 10 minutes,but the LED ist still off and the spirit setting shows me still,that geo-link is not connected.
|
|||||
| Author: | ZeXx86 [ Tue 25. Sep 2018 19:16:41 ] |
| Post subject: | Re: Geo-Link is not connected after update |
Unfortunately waiting will not finish the calibration. Calibration must be finished according the manual. Please see this page: http://manual.spirit-system.com/index.p ... on_process |
|
| Author: | ZeXx86 [ Tue 25. Sep 2018 19:19:38 ] |
| Post subject: | Re: Geo-Link is not connected after update |
This video from one pilot can help you with the process: |
|
| Author: | speed kills [ Tue 25. Sep 2018 19:42:06 ] |
| Post subject: | Re: Geo-Link is not connected after update |
thanks for the links....now I got connection to Geo-Link...I think,I was a little impatient with calibration... thx a lot....now it's working  Have a nice evening. Greetings, Robert |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|