Just tested geolink with position hold and altitude limit and I can say is,so far this is amazing..
Thanks Tomas and hopefully,you able to give as a better mounting option.
Sent from my SM-N950W using Tapatalk
| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Geolink Inclination... https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=2838 |
Page 1 of 1 |
| Author: | Rufus [ Sun 16. Sep 2018 18:44:27 ] |
| Post subject: | Geolink Inclination... |
Good day all.... I can't seem to get the X parallel and Y perpendicular to zero no matter how much I try with my mounting. It's always a couple of point degrees off. Does is it have to be exactly 0 degrees ? In the manual,it says the heading can be plus or minus to 4 for the 90 degree heading north which I've managed to accomplish. Any tip or help will be appreciated. Thanks. Sent from my SM-N950W using Tapatalk |
|
| Author: | ZeXx86 [ Sun 16. Sep 2018 21:28:05 ] |
| Post subject: | Re: Geolink Inclination... |
Hello, could you describe what is causing you troubles in getting it more precisely? Ideally it should be in range of +/- 1° error. Basically if your model has stright tail boom then you do not have to worry about Y axis since it should be perfect. But regarding X axis you only have to move the module little bit to achieve 0°. But you have to be sure the model is really at a flat surface. |
|
| Author: | Rufus [ Sun 16. Sep 2018 22:11:47 ] |
| Post subject: | Re: Geolink Inclination... |
ZeXx86 wrote: Hello, could you describe what is causing you troubles in getting it more precisely? Ideally it should be in range of +/- 1° error. Basically if your model has stright tail boom then you do not have to worry about Y axis since it should be perfect. But regarding X axis you only have to move the module little bit to achieve 0°. But you have to be sure the model is really at a flat surface. I'm on a level surface,I think but it's my mounting option that's giving me trouble. I managed to get to .5 and .3 respectively. There's a lot of try and error with the mounting since all these heli's have different COG.I will have a perfect zero and zero when I mount the geolink but after the double sided tape and mount settles down,it changes.I'm mounting it on logo 480xx. Sent from my SM-N950W using Tapatalk |
|
| Author: | Rufus [ Mon 17. Sep 2018 1:06:54 ] |
| Post subject: | Re: Geolink Inclination... |
Just tested geolink with position hold and altitude limit and I can say is,so far this is amazing.. Thanks Tomas and hopefully,you able to give as a better mounting option. Sent from my SM-N950W using Tapatalk |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|