| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Spirit Geo-Link Connection https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=2695 |
Page 1 of 1 |
| Author: | Jeeprogue [ Tue 07. Aug 2018 15:41:26 ] |
| Post subject: | Spirit Geo-Link Connection |
I have a Spirit Pro and i am currently using an AR4649T with a Satellite and the Uni-Cable for HobbyWing Telemetry. My Geo-link arrives tomorrow and in the manual it specifies that the Geo-Link uses the Secondary Satellite port on the Spirit Pro, the Uni Cable for HobbyWing Telemetry uses the Primary Satellite Port. Is it possible to use a Y harness on one of the 2 satellite ports to and use the Telemetry, Geo-Link, and Satellite RX, or will i have to remove either the Satellite or Telemetry? |
|
| Author: | rediary [ Tue 07. Aug 2018 18:33:46 ] |
| Post subject: | Re: Spirit Geo-Link Connection |
+1 Also very interested in how this will work! |
|
| Author: | LogoX2 [ Tue 07. Aug 2018 19:10:43 ] |
| Post subject: | Re: Spirit Geo-Link Connection |
Use a Spektrum V2 adapter to plug the Sat into the Rud port. You can use a Y cable to apply power to the 4649T or power it using the Aux 2 port. |
|
| Author: | Jeeprogue [ Wed 08. Aug 2018 0:06:08 ] |
| Post subject: | Re: Spirit Geo-Link Connection |
i was scrolling through some of the other posts here, i came across this thread viewtopic.php?f=20&t=2677 discussing setup using a Satellite RX and the Geo-Link on the regular Spirit, ZeXx86 specifies that on the regular spirit with only 1 port, a Y-harness can be used for the Geo-Link and Satellite RX. one would assume this means the same would work with the Spirit Pro? |
|
| Author: | rediary [ Wed 08. Aug 2018 18:31:20 ] |
| Post subject: | Re: Spirit Geo-Link Connection |
Would something like this work providing power to two accessories from a single sat port? https://www.amainhobbies.com/spektrum-rc-3-yharness-jst-ultra-lightweight-spmyhjst3ul/p21849?gclid=CjwKCAjwqarbBRBtEiwArlfEIAPl2Mid11hTVhOuOL7XpKdHIGsGZJvb9yDoTeZWcNA4Uc70arZN3hoCo1QQAvD_BwE |
|
| Author: | LogoX2 [ Wed 08. Aug 2018 19:52:23 ] |
| Post subject: | Re: Spirit Geo-Link Connection |
No you can NOT use a Y cable on the Geo Link. It must be used by itself on the Sat port. |
|
| Author: | ZeXx86 [ Sat 11. Aug 2018 13:07:23 ] | ||
| Post subject: | Re: Spirit Geo-Link Connection | ||
Here is how you can connect 3x Spektrum satellites and 1x SPM4649T together with Spirit Pro. You can also connect 4th Spektrum satellite instead of SPM4649T - it is only necessary to modify Spektrum adapter so that signal wire is separately connected at the AIL pin.
|
|||
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|