Spirit System https://www.spirit-system.com/phpBB3/ |
|
Hobbywing Platinum 130A HV V4 Connection https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=2557 |
Page 1 of 1 |
Author: | Michael [ Fri 11. May 2018 0:14:43 ] |
Post subject: | Hobbywing Platinum 130A HV V4 Connection |
I would appreciate some advice on connecting the following system. Spirit Pro Hobbywing Platinum 130A HV V4 (internal BEC) SPM4649T Telemetry Receiver SPM9645 Satellite Receiver Installation is on a Trex 700 and my Tx is a DX9. This is what I understand so far : Spirit Pro SYS CH0 CH1 Pitch Servo CH2 Elevator Servo CH3 Aileron Servo CH4 Rudder Servo AUX2 AUX1 HW ESC Throttle Signal Cable RUD Red/Brown wires to SPM4649T Bind/Serial port (using Jeti integration cable) ELE/PIT/AIL Orange wire to SPM4649T Bind/Serial Port (using Jeti integration cable) HW ESC Programming Port connected to Spirit primary satellite port using Telem UNI cable SPM9645 Satellite Connect to secondary satellite port on the Spirit Questions (if the above is correct) : 1) What do I do with the BEC Output cable (Red/Brown) from port -+R on the HW ESC (CH0 or Aux2 on the Spirit) ? 2) What do I do with the RPM Signal wire (Yellow) from port -+R on the HW ESC ? 3) Do I use the Laps/Volts/RPM port on the SPM4649T ? Many thanks Michael |
Author: | ZeXx86 [ Fri 11. May 2018 12:30:22 ] |
Post subject: | Re: Hobbywing Platinum 130A HV V4 Connection |
Hello, your wiring seems to be correct. 1) AUX2 port or CH0 port can be used. 2) No need to connect it if Governor from the unit will be unused. 3) This depends on you. You can connect BEC voltage there - this will allow BEC voltage measurement. |
Author: | Michael [ Fri 11. May 2018 20:55:44 ] |
Post subject: | Re: Hobbywing Platinum 130A HV V4 Connection |
Many thanks for your help with this. |
Author: | treys1 [ Fri 11. May 2018 21:48:26 ] |
Post subject: | Re: Hobbywing Platinum 130A HV V4 Connection |
You can see here how I wire up to get RX voltage in the telemetry: viewtopic.php?f=20&t=2385 |
Author: | Michael [ Sat 12. May 2018 2:19:38 ] |
Post subject: | Re: Hobbywing Platinum 130A HV V4 Connection |
Thank you very much for sending me this |
Page 1 of 1 | All times are UTC + 1 hour |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |