I'm using the Graupner MZ-24 as my radio and have the throttle servo connected directly to channel 6 on the receiver. I had to reverse direction the channel 6 to get the throttle moving in the right direction. I noticed in the FBL software that channel 6 is assigned to pitch. Does it matter that the servo graph in the radio moves in the opposite direction of the graph in the FBL software? Or should I just use channel 1 on the RX and reverse the direction so the throttle moves in the correct direction and keep channel 1 unassigned in the FBL?
Graupner is saying the default channel map is that Channel 1 is collective and Channel 6 is throttle. They are saying I should change the channel assignment in the Spirit. The default channel assignment is:
Pitch = CH 1
Aileron = CH 2
Elevator = CH 3
Rudder = CH 4
Free = CH 5
Throttle = CH 6
Should I map the channels in the software to match the above?
| Attachments: |
|
Untitled.jpg [ 1.05 MiB | Viewed 348 times ] |
|
Screen Shot 2018-05-07 at 12.56.34 AM.png [ 101.93 KiB | Viewed 348 times ] |