| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| pb JETI DC16 > SPIRIT > ESC Castle Création https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=2547 |
Page 1 of 2 |
| Author: | passe partout [ Wed 02. May 2018 8:40:28 ] |
| Post subject: | pb JETI DC16 > SPIRIT > ESC Castle Création |
Hello, I am sorry I do not speak English I use a translator. I concerns is; I have Spirit (red and black), I went up on a copter with an ESC DC 160 HV, the controller and the module are recognized by the radio JETI DC 16, the telemetry does not work, just the % of vibrations. |
|
| Author: | ZeXx86 [ Wed 02. May 2018 8:49:51 ] |
| Post subject: | Re: pb JETI DC16 > SPIRIT > ESC Castle Création |
Hello, do you have CC Telem cable? Please check this guide: http://manual.spirit-system.com/index.p ... _Telemetry There you can see all steps that are needed to make it work. |
|
| Author: | passe partout [ Wed 02. May 2018 8:55:56 ] |
| Post subject: | Re: pb JETI DC16 > SPIRIT > ESC Castle Création |
Thank you for this fast answer, everything was make as on the link, but there is no telemetry, the resistance of 10k was welded. THE ESC is recognized, and works, when I put the son with resistance if I cut the RX without removing lipos, the engine turns(shoots) 2 seconds.       
|
|
| Author: | passe partout [ Wed 02. May 2018 12:40:11 ] | ||
| Post subject: | Re: pb JETI DC16 > SPIRIT > ESC Castle Création | ||
Version Spirit 2.3.4 ESC 4.25
|
|||
| Author: | ZeXx86 [ Wed 02. May 2018 14:39:08 ] |
| Post subject: | Re: pb JETI DC16 > SPIRIT > ESC Castle Création |
So the ESC is working also with modified cable (with 10kOhm resistor) - you can control the throttle, right? It is important that it is working well. Can you tell me what ESC do you exactly have? |
|
| Author: | passe partout [ Wed 02. May 2018 15:35:20 ] |
| Post subject: | Re: pb JETI DC16 > SPIRIT > ESC Castle Création |
Mode 1 gaz à droite ESC castle créations Phenix edge HV 160 Even with cable him 10k the ESC does not arm itself, orders it gases is settled in at the end of race 87 % 99 %. |
|
| Author: | ZeXx86 [ Wed 02. May 2018 15:44:02 ] |
| Post subject: | Re: pb JETI DC16 > SPIRIT > ESC Castle Création |
Did you configured Throttle Range according the manual? See this page: http://manual.spirit-system.com/index.p ... Castle_ESC If not, then ESC will not initialize at all. Castle ESCs require different throttle range than other ESCs. Also please note, that with Link-Live feature in the ESC it can work only with 10KOhm resistor. |
|
| Author: | passe partout [ Wed 02. May 2018 16:14:54 ] |
| Post subject: | Re: pb JETI DC16 > SPIRIT > ESC Castle Création |
Gaz +100% - 100% test A: ESC > link live = disabled no R10K Spirit > telemetrie setting = Disabled Jeti > Spirit > télémétrie setting > Disabled moteur Ok I have branch White wire RPM output Signal (PIT pine), return on screen JETI > RPM = 0 test B: ESC > link live = enabled R10K Between + and signal Spirit > telemetry setting = Castle créations & Talon Jeti > Spirit > télémétrie setting > Castle création & Talon moteur Not Ok Not initialized I have redo test with an ESC PHOENIX EDGE 120 HV, test A or B identical results |
|
| Author: | ZeXx86 [ Wed 02. May 2018 19:24:55 ] |
| Post subject: | Re: pb JETI DC16 > SPIRIT > ESC Castle Création |
Thank you for the details. Do you use an external BEC? Unfortunately the only problem that I am thinking about is in the cable with 10kOhm resistor. Did you tried it with your other unit too? |
|
| Author: | passe partout [ Wed 02. May 2018 19:36:16 ] |
| Post subject: | Re: pb JETI DC16 > SPIRIT > ESC Castle Création |
Thank you to take into account my concerns. No I use 2 lipos batteries with an electronic inter. I commanded you a cordon R10k in the doubt of my cordon but I think of being on my assembly. I have to receive ASAP With the ESC 120 or 160 identical results. Assembly prototype, negative result, the ESC does not arm, the engine does not work. 
|
|
| Page 1 of 2 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|
