Hi.
My protos went down after I lost all power during tic-toc.(Just blades, boom, shafts was broken)
This was the 6th flight of the day, first "hard" one.
Look like I just lost the power to the esc if you see at the CC log.
I can't remember hearing any pips from the motor after the crash, but I unplugged it quite fast due to binding of the servos.
I have backup guard, so the spirit and servos had power al the time.
I put power on the system on the bench just to check the esc after the crash, all is fine.
But maybe I that way the log from spirit is a little strange ?
Please note that the antenna was ripped out of the receiver during the crash.
The helicopter has been crashed many times, so electronic have had a hard life.
Last crash I cut the boom clean of during rescue(my fault, way to much rescue pitch, 800 blades, and worn dampers)
Had to clue half of the magnet in the motor, they were loose...
Set up:
Protos 800.
xnova 4530
CC ICE 2 160A
Hobbywing BEC
Optipower back up guard
Spirit (red)
Futaba servo.
Frsky x4r receiver.
Regards
Karl Morten
| Attachments: |
CC protos crash.csv [508.15 KiB]
Downloaded 58 times |
|
spirit-log-2018-04-30-173000.pdf [79.5 KiB]
Downloaded 255 times |
