ZeXx86 wrote:
Hello,
thank you for your interest in our products!
1. No, gel is not recommended at all.We recommend to use our supplied double sided tape. The unit should hold firmly.
2. No, the unit comes with already cutted tapes exactly for the Spirit Pro.
3. It should work, but correct adjustment is needed (same for other units). I recommend to use normal TC curves first.
4. We are trying to describe everything in the manual/guides. So it depends on what you are interested specifically.
5. If using Governor, set only flat curves, also for idling. Then change the TC from e.g. 12% - 75% to get smooth spoolup.
thank you for your interest in our products!
1. No, gel is not recommended at all.We recommend to use our supplied double sided tape. The unit should hold firmly.
2. No, the unit comes with already cutted tapes exactly for the Spirit Pro.
3. It should work, but correct adjustment is needed (same for other units). I recommend to use normal TC curves first.
4. We are trying to describe everything in the manual/guides. So it depends on what you are interested specifically.
5. If using Governor, set only flat curves, also for idling. Then change the TC from e.g. 12% - 75% to get smooth spoolup.
Thank you for the reply. Just some clarification on point 5. I would typically use some trim on the throttle to get a good idle are you recommending that no trim be used and have a curve such as 0-10-50-50? I have attached some screen shots from my radio.
| Attachments: |
|
IMG_0200.jpg [ 145.37 KiB | Viewed 352 times ] |
|
IMG_0199.jpg [ 144.83 KiB | Viewed 352 times ] |
|
IMG_0198.jpg [ 143.91 KiB | Viewed 352 times ] |