| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Hobbywing SCM connection ? https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=2504 |
Page 1 of 1 |
| Author: | Dawiev [ Tue 03. Apr 2018 5:05:14 ] | ||
| Post subject: | Hobbywing SCM connection ? | ||
Hi, HW released the module (SCM) to correct the telemetry for their OPTO modules. I'm using a 200A ESC. With Spirit, the connection only takes the signal pin from the RPM port. What is the correct way to connect this new module please ?
|
|||
| Author: | ZeXx86 [ Tue 03. Apr 2018 7:18:42 ] |
| Post subject: | Re: Hobbywing SCM connection ? |
Hi, the R with Signal out will be connected by a single wire with the PIT pin or by a servo cable with middle pin removed (very important). The telemetry (P) port (Signal out side) will be connected by the Telem UNI cable. |
|
| Author: | Dawiev [ Tue 03. Apr 2018 7:27:10 ] |
| Post subject: | Re: Hobbywing SCM connection ? |
Thanks! ! |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|
