Hello

I guess my last post is closed ( solved).

after all settings on my Futaba T8FG like your "set up guide for Futaba" : gain giro at 60%

On diagnostic :
Giro / normal condition 68%
Giro / SH button ON / 63% ("Rescue" appears)
Is it the right setting ? why not 60% for nc and -60% for rescue ?

Thank for you help

Regards

Hello!

It looks to be good. There could be little bit difference between % if channel center is not exact.
For Gyro channel you can fix it by using a Subtrim for Gyro channel in your radio until you will obtain same percentages in both directions.

If you can see + Rescue, then it mean that you have entered negative gyro gain. This is correct behavior. But the actual Gyro Gain for the unit will be 60%. So basically all is correct and even with the gain difference you can fly now.

S-BUS connection is little bit more precise, because it is tailored exactly for Futaba and data are sent digitally.
But it is small difference and PWM will work as well.

_________________
Spirit System developer

Hello,

As you say it's simpler in S BUS, I connected a receiver FRSKY TFR8 SB.
Set up ok with giro gain + 60% and -60% in RESCUE.

But a question?
Which channel of the TFR8 receiver should I connect the optional cable from AUX1 of the spirit module?
(I already connected the ESC on channel 3 of the receiver S BUS.)

Many thanks

Hello,

you can use any other channel.

_________________
Spirit System developer

Hello

Thank you for your availability

Regards