| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| RPM displayed on Jeti DS16 - using Scorpion governor https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=2232 |
Page 1 of 1 |
| Author: | Malc1 [ Wed 20. Sep 2017 18:25:57 ] |
| Post subject: | RPM displayed on Jeti DS16 - using Scorpion governor |
I am using the internal governor on a Scorpion Tribunus 200A esc and have RPM data being displayed on my Jeti TX. Will this be the correct RPM being displayed? I have noticed that in the Scorpion software when running the motor the RPM is much much higher and certainly can not be the RPM of the rotor head. Or do I need to be using the Spirit governor for this work correctly, and be able to use it to set up the helicopter? I have previously set up the correct main gear ratio in the Spirit software. |
|
| Author: | ZeXx86 [ Wed 20. Sep 2017 18:34:38 ] |
| Post subject: | Re: RPM displayed on Jeti DS16 - using Scorpion governor |
You have to set Sensing Divider and Gear Ratio. Then it should match the head speed. This can be done in the General - Governor/Throttle window (after enabling Governor temporarily). |
|
| Author: | Malc1 [ Wed 20. Sep 2017 19:47:07 ] |
| Post subject: | Re: RPM displayed on Jeti DS16 - using Scorpion governor |
Great! Many thanks again. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|