| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Cable for µSpirit and Jeti EX https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=2107 |
Page 1 of 1 |
| Author: | Blademaster [ Tue 25. Jul 2017 9:52:34 ] |
| Post subject: | Cable for µSpirit and Jeti EX |
Hello, do I have to order an additional cable to connect a Jeti Rex 3 receiver to the µSpirit ? Regards, Dirk |
|
| Author: | ZeXx86 [ Wed 26. Jul 2017 11:15:00 ] |
| Post subject: | Re: Cable for µSpirit and Jeti EX |
If you want to use EX Bus, then you will ideally need Jeti integration cable and 2x JST-Servo cables. If you want to save a weight, you can do your own jeti integration cable just by buying for example JST-RX cable and combining it with supplied JST-RX cable. 1. Plug off orange wire from the JST-RX with a needle. 2. Use any free JST connector or use it from other cable such as JST-RX so that there is no wire in it. 3. Connect orange wire from the step 1 to the free JST connector in the same position as it was. So basically it will look like Jeti integration cable, but with 2 JST connectors and 1 servo connector at the end. If you do not need integration, you can use supplied JST-RX for UDI or PPM connection. So in this case nothing else than supplied cable is needed. |
|
| Author: | Blademaster [ Wed 26. Jul 2017 12:39:24 ] |
| Post subject: | Re: Cable for µSpirit and Jeti EX |
Thanks for the info ! |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|