Hello!
My Spirit software does not start anymore ...?
I can only open the demo mode.
The spirit works normally The software I have already installed!
My other Spirit FBL work!

Thanks!

Make sure the plug to the FBL is fully in... that's what happens when the PC Software does not "see" the unit...

_________________
Oxy 2 ♦ X-Vert ♦ Warp 360 ♦ Blade 450X ♦ Blade 450X Nightflyer ♦ Goblin 500 (RIP) ♦ 2 X mCPX v2 ♦ night fly mQX ♦ LadyMQX ♦ nano QX ♦ nano QX FPV ♦ Inductrix ♦ DX8 G1

Alternatively the USB interface was damaged, please check that the wires are good, especially on the PCB.
Some users are pulling it by cables, which is not making them happy
Or do you remember what was the last operation when it worked? Did you reconfigured something?

_________________
Spirit System developer

Tomas, you're right!
I have the cable re-soldered and the software works again perfectly!

Thanks!!!

Greeting Frank

Good job!
Thank you for the message.

_________________
Spirit System developer

Hi!
I do not know what's going on, now it is not again. Again goes only the demo mode ...?

Hi,

maybe the problem is again there.
From the photo I can see that there is some wire which is nearly touching other one.
Maybe it shorted there.

_________________
Spirit System developer

Sorry Tomas,
the second photo is after the new soldering.
No cables or contacts touch on the photo.
Another idea?

Are you sure that you have not enabled for example Kontronik telemetry? This would disable USB communication as described in the Telemetry window.

_________________
Spirit System developer

Tomas, this is another post...!?