Hello,

I am using a Jeti DS-16 for my helicopters. In the software of the DS-16 there is the menu "Servo Assignment". Is there a specific order for the functions Throttle, Pitch, Roll, Elevator, Yaw, Gyro Sens, Banks and Rescue in this menu? What has to be under 1, 2 etc.?

Kind regards

Chris

In the Jeti Integration document in the Wiki (http://manual.spirit-system.com/index.p ... ntegration) it's suggested to set it like this:

Channel Layout
1 Throttle
2 Aileron
3 Elevator
4 Pitch
5 Rudder
6 Gyro sens.
7 Bank (if used)
8 Stabi (if used)

_________________
Oxy 2 ♦ X-Vert ♦ Warp 360 ♦ Blade 450X ♦ Blade 450X Nightflyer ♦ Goblin 500 (RIP) ♦ 2 X mCPX v2 ♦ night fly mQX ♦ LadyMQX ♦ nano QX ♦ nano QX FPV ♦ Inductrix ♦ DX8 G1

Thank you! I have found the screenshot of your link in the meantime.

I have got another problem at this step. It is possible to activate a governor in the DS-16: You can set "yes" or "no". What is my choice for an electric helicopter with a Kontronik ESC (Kosmik)?

Since Kosmik have internal governor then the correct option is "No" - no for Spirit Governor.

_________________
Spirit System developer

Thank you!

And what is If I have a gas powered helicopter? Can I use the internal governor of the spirit system? (Then I suppose I set to "Yes"). And when I use a separate governor (like Futaba), than I have to set "No"?

Yes, you are perfectly right.

_________________
Spirit System developer

Thank you!

It is off topic, but my last question

Spirit offers "Bank switching": I normally use three different flight modes (hovering, aero, 3D) with three different settings. The switch has three positions. My question: Use pilots for bank switching the same switch? Or use they a seperate switch?