|
It is currently Sun 24. Nov 2024 4:35:32
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
Necroscope
|
 Posted: Thu 01. Jun 2017 0:50:16 |
|
Joined: Sat 27. May 2017 21:34:30
Posts: 9
|
|
I am setting up my first Spirit Pro and have intergration with my DS-16.
While checking everything, I found that my tail wasn't going to it's furthest travel.
I went into Device Manager and found the the servo travel was set to 85%.
So I changed the travel to 100% in both directions. I saw the servo adjusting as I did this.
I the repowered the heli and tried the tail again, but there didn't appear to be any change.
I went back into Device Manager, and found that the new setting had been saved.
I have only checked this on the work bench, not in flight.
Am I misisng something.
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Thu 01. Jun 2017 12:40:55 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Try to increase your Gyro gain. If it is too low, the servo will not reach the end points.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 20 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
