| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Tail servo end points https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=2004 |
Page 1 of 1 |
| Author: | Necroscope [ Thu 01. Jun 2017 0:50:16 ] |
| Post subject: | Tail servo end points |
I am setting up my first Spirit Pro and have intergration with my DS-16. While checking everything, I found that my tail wasn't going to it's furthest travel. I went into Device Manager and found the the servo travel was set to 85%. So I changed the travel to 100% in both directions. I saw the servo adjusting as I did this. I the repowered the heli and tried the tail again, but there didn't appear to be any change. I went back into Device Manager, and found that the new setting had been saved. I have only checked this on the work bench, not in flight. Am I misisng something. |
|
| Author: | ZeXx86 [ Thu 01. Jun 2017 12:40:55 ] |
| Post subject: | Re: Tail servo end points |
Try to increase your Gyro gain. If it is too low, the servo will not reach the end points. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|