| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Governor and SRXL https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=1988 |
Page 1 of 1 |
| Author: | George Baker [ Thu 25. May 2017 2:28:55 ] |
| Post subject: | Governor and SRXL |
Hi, I'm installing a new Spektrum AR9030T receiver and connecting it to the Spirit (not pro) with an SRXL connection. Will the SRXL connection pass the RPM telemetry signal from the receiver to the Spirit so the Spirit governor can be used or does the RPM sensor have to be connected directly to the Spirit to use the Spirit governor? I'm thinking that would be too good to be true but it doesn't hurt to ask. Thanks |
|
| Author: | ZeXx86 [ Fri 26. May 2017 7:05:58 ] |
| Post subject: | Re: Governor and SRXL |
Hi, when the RPM sensor is not present, RPM data are displayed from the ESC. So it support both. |
|
| Author: | George Baker [ Fri 26. May 2017 16:52:35 ] |
| Post subject: | Re: Governor and SRXL |
Thanks, I have a magnetic RPM sensor connected to the receiver. Gas engine servo for throttle. Any way to pass RPM signal from the RX to Spirit in order to use Spirit governor? |
|
| Author: | jgiannakas [ Sat 27. May 2017 4:29:41 ] |
| Post subject: | Re: Governor and SRXL |
Just splice the wire and plug it in both. |
|
| Author: | George Baker [ Mon 29. May 2017 6:46:43 ] |
| Post subject: | Re: Governor and SRXL |
Question; "Any way to pass RPM signal from the RX to Spirit in order to use Spirit governor?" X-Bus? SRXL? |
|
| Author: | ZeXx86 [ Tue 30. May 2017 7:38:17 ] |
| Post subject: | Re: Governor and SRXL |
You can do so always by a RPM sensor, so it is not entirely dependent on the used protocol. Unfortunately it is not possible to pass a RPM signal from your receiver to the unit. |
|
| Author: | George Baker [ Tue 30. May 2017 14:06:05 ] |
| Post subject: | Re: Governor and SRXL |
OK, Thank you. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|