Spirit System https://www.spirit-system.com/phpBB3/ |
|
Esc telemetry hobbywing v4 60A https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=1978 |
Page 1 of 1 |
Author: | torro [ Sun 14. May 2017 16:36:26 ] |
Post subject: | Esc telemetry hobbywing v4 60A |
Hi, Will battery current and consumed capacity be available in near future? Greets, Flo |
Author: | ZeXx86 [ Sun 14. May 2017 16:39:09 ] |
Post subject: | Re: Esc telemetry hobbywing v4 60A |
Hi, unfortunately no, this ESC does not support current measurement, which mean that also capacity measurement is not possible. |
Author: | torro [ Sun 14. May 2017 16:44:35 ] |
Post subject: | Re: Esc telemetry hobbywing v4 60A |
Ok, Thanks |
Author: | torro [ Mon 15. May 2017 7:31:27 ] |
Post subject: | Re: Esc telemetry hobbywing v4 60A |
Where can ich find this little white plug? I need to make the cable. Something special about the pin assignement? Greets, Flo |
Author: | ZeXx86 [ Mon 15. May 2017 9:16:05 ] |
Post subject: | Re: Esc telemetry hobbywing v4 60A |
You can buy the cable from our eshop. Connector that is used is one that can be found with Spektrum cables. Normally it is not available in end-user stores. If you will buy a Spektrum cable it will probably be more expensive than our finished cable. You need also special crimping tool from JST for the connector. You can try to find a JST to Servo adaptor cable, the only thing you have to do is to disconnect red wire (positive). Only ground and signal wires must be present. |
Author: | torro [ Mon 15. May 2017 10:31:09 ] |
Post subject: | Re: Esc telemetry hobbywing v4 60A |
The cable is on backorder in your store I have crimping pliers for jst xh and the Standard servo plugs. The little white plug seems to be much smaller than jst xh. But i could buy a Spektrum cable and crimp my own servo plug on it. |
Author: | torro [ Mon 15. May 2017 10:33:25 ] |
Post subject: | Re: Esc telemetry hobbywing v4 60A |
Would this fit? http://m.ebay.de/itm/1x-Spektrum-Satell ... nav=SEARCH Spektrum satellite cable 90cm. Thanks! |
Page 1 of 1 | All times are UTC + 1 hour |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |